TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-34
ADD SUBNET Command for TCP6MAN
DUAL Mode Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
SUBNET $ZZTCP.*.subnet-name
is the name of the SUBNET object. The fully-qualified SUBNET name is
$ZZTCP.*.subnet-name (you must add SUBNETs to all configured TCP6MONs.)
The naming convention for SUBNETs is seven characters. The first character must
be a letter. HP recommends making the first two characters SN. If you specify a
portion of the fully-qualified name in a prior ASSUME command, you can omit that
portion of the name in this command. For information about the ASSUME
command, see the SCF Reference Manual for G-Series RVUs or the SCF
Reference Manual for H-Series RVUs.
FAMILY DUAL
specifies that the SUBNET is configured as a failover pair in both INET (IPv4) and
INET6 (IPv6) environments.
TYPE ETHERNET
is the type of SUBNET to be added. For IPv6 configurations that do not involve
tunneling, the only valid type is ETHERNET.
IPADDRESS ip-addr
is the IPv4 address associated with this SUBNET interface. This attribute is
required. There is no default.
ADD [ /OUT file-spec/ ] [ SUBNET subnet-spec ]
, FAMILY DUAL
, TYPE ETHERNET
, IPADDRESS ip-addr
, DEVICENAME lif-name
[ , IRDP { ON | OFF } ]
[ , SUBNETMASK mask-val ]
[ , IPV6INTERFACEID ipv6-id ]
[ , IPV6ADDRESS ipv6-addr ]
[ , IPV6PREFIX ipv6-prefix ]
[ , IPV6NUD { ON | OFF } ]
[ , IPV6MTU int ]
[ , IPV6REACHABLETIME int ]
[ , IPV6RETRANSMITIMER int ]
[ , IPV6DADRETRIES int ]
[ , IPV6HOPLIMIT int ]
[ , IPV6RAENABLE { ON | OFF } ]
[ , FAILOVER { SHAREDIP| NONSHAREDIP } ]
[ , LNPTPLIST "tcp6sam list" ]