TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-60
DELETE ROUTE Command for TCP6MAN
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ENTRY $ZZTCP.*.entry-name
is the name of the ENTRY object to be deleted. The fully-qualified entry name is
$ZZTCP.*.entry-name (you must alter the SUBNET on all configured
TCP6MONs). You can delete all entries by substituting the wild card (*) for the
entry-name. If you omit the object name, SCF uses the assumed object name.
For information about the ASSUME command, see the SCF Reference Manual for
G-Series RVUs or the SCF Reference Manual for H-Series RVUs.
Example
To delete the entry on all TCP6MONs:
-> DELETE ENTRY EA1
Considerations

When the DELETE operation is completed, the definition of the entry you specified
for deletion is removed from the subsystem.

The DELETE SUBNET operation also deletes all the entries dependent on this
interface/SUBNET and removes the static entries dependent on this
interface/SUBNET from the configuration database. See DELETE SUBNET
Command for TCP6MAN on page 8-61.
DELETE ROUTE Command for TCP6MAN
The DELETE ROUTE command removes a ROUTE from the NonStop TCP/IPv6
subsystem. Only ROUTEs in the STOPPED state can be deleted.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
DELETE [ /OUT file-spec/ ] [ ENTRY $ZZTCP.*.entry-name ]
DELETE [ / OUT file-spec / ] [ROUTE $ZZTCP.#ZPTMn.route-name]