TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-99
INFO SUBNET Command for TCP6SAM
Examples
To return information about all running SUBNETs on the TCP6MON object running in
TCP6SAM’s primary processor:
-> INFO SUBNET $ZTC1.*
INFO SUBNET for TCP6SAM Display Format
The format of the INFO SUBNET display for TCP6SAM is (an asterisk (*) indicates an
alterable attribute):
Name
is the name of the SUBNET.
Devicename
is the name of the SLSA LIF that provides access to the Ethernet LAN. Note that
with loopback SUBNETs, the value \NOSYS.NOIOP, meaning no system, no
device name, is displayed. This value is displayed because loopback SUBNETs
are routed internally so that there is no device name to display.
IPADDRESS
is the Internet address of this SUBNET and all the IP addresses of the aliases
associated with the SUBNET.
TYPE
is the SUBNET type. Possible values are Ethernet and loopback.
SUBNETMASK
is a 32-bit integer that specifies which portion of the network number and the IP
host address is to be masked to define a SUBNET.
SuName
is not supported for NonStop TCP/IPv6.
TCPIP Info SUBNET \MYSYS.$ZTC1.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#LOOP0 \NOSYS.$NOIOP 127.0.0.1 LOOP-BACK %HFF000000 OFF N
TCPIPV6 Info SUBNET \MYSYS.$ZTC1.*
Name Devicename *IPADDRESS TYPE *SUBNETMASK SuName QIO *R
#SN2 \MYSYS.LAN04 172.17.221.74 ETHERNET %HFFFFFF00 ON N
Note. IPv6 addresses do not display in the INFO SUBNET command for TCP6SAM.