TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-107
NAMES ROUTE Command for TCP6MAN
NAMES ENTRY Display Format
The display format of the NAMES ENTRY command is:
NAMES ROUTE Command for TCP6MAN
The NAMES ROUTE command displays the names of the routes for the NonStop
TCP/IPv6 subsystem.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ROUTE ROUTE $ZZTCP.#ZPTMn.*
is the name of the route. The route name is $ZZTCP.#ZPTMn.*. You can
substitute the wild card (*) for the TCP6MON name; doing yields NAMES
information for routes on all TCP6MONs. The wild card is used in place of the
route-name because the purpose of the NAMES ROUTE command is to obtain
a list of all routes. If you omit the process name, SCF uses the process name
established in a previous ASSUME command. For more information about the
ASSUME command, see the SCF Reference Manual for G-Series RVUs or the
SCF Reference Manual for H-Series RVUs.
Examples

To request a list of the routes associated with $ZZTCP.#ZPTM1:
-> NAMES ROUTE $ZZTCP.#ZPTM1.*

To request a list of all the routes in the NonStop TCP/IPv6 subsystem:
-> NAMES ROUTE $ZZTCP.*.*
TCPIPV6 Names ENTRY \MYSYS.$ZZTCP.#ZPTM2.*
ENTRY
DA2_1 EA01
NAMES [ / OUT file-spec / ] [ROUTE $ZZTCP.#ZPTMn.* ]