TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-108
NAMES ROUTE Command for TCP6SAM
NAMES ROUTE Display Format
The format of the display for the NAMES ROUTE command is:
The format of the display for the NAMES ROUTE command for all routes in the
NonStop TCP/IPv6 is:
NAMES ROUTE Command for TCP6SAM
The NAMES ROUTE command for TCP6SAM displays the names of the routes
configured in the same processor as the TCP6SAM process.
Command Syntax
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
ROUTE $TCP6SAM-name.*
is the name of the route. The wild card (*) is used in place of the route-name
because the purpose of the NAMES ROUTE command is to obtain a list of all
routes. If you omit the process name, SCF uses the process name established in a
previous ASSUME command. For more information about the ASSUME command,
see the SCF Reference Manual for G-Series RVUs or the SCF Reference Manual
for H-Series RVUs.
Example
To request a list of the routes running in the same processor as TCP6SAM:
SCF> NAMES ROUTE $ZTC1.*
TCPIPV6 Names ROUTE \MYSYS.$ZZTCP.#zptm1.*
ROUTE
RT1 RT3 DEF
TCPIPV6 Names ROUTE \MYSYS.$ZZTCP.*.*
ROUTE
RT1 RT3 DEF
NAMES [ / OUT file-spec / ]
[ROUTE $TCP6SAM-name.*]