TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-190
STATUS SUBNET Command for TCP6MAN
FailOver
indicates whether the SUBNET is failover enabled or not. When the SUBNET is
failover enabled, possible values are:
SharedIP
indicates whether the SUBNET has the same SUBNET IP address as its brother.
YES-PRIMARY
indicates that this SUBNET is failover-capable and has the same SUBNET IP
address as another SUBNET.
YES-BACKUP
indicates that this SUBNET is failover-capable and has the same SUBNET IP
address as another SUBNET.
NO
indicates that this SUBNET does not have the same SUBNET IP address as
another SUBNET.
Alias
indicates that this SUBNET has been configured for IP aliasing addresses.
A-Subnet
is the associated SUBNET in a failover pair.
M-State
is in the UP state when the SUBNET’s adapter has detected a link pulse from the
network connection. A DOWN state indicates problems with the cabling or the
associated network equipment.
IPv6
indicates, when designated with YES, that this SUBNET is enabled for IPv6 use.
NO indicates this SUBNET is disabled for IPv6 use.
IPv4
indicates, when designated with YES, that this SUBNET is configured with an IPv4
address. NO indicates this SUBNET is not configured with an IPv4 address.
V4 The SUBNET is only IPv4 failover enabled
V6 The SUBNET is only IPv46 failover enabled
V4-V6 The SUBNET is failover enabled for both IPv4 and
IPv6.