TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

Quick Start
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
1-3
IIA. Install NonStop TCP/IPv6 (#ZZTCP is not in the
Configuration Database)
e. Check if the TCP6MAN process has been added as a generic process to the
system configuration database by entering this command at the SCF prompt.
(If ZZTCP has not been added as a generic process, perform IIA. Install
NonStop TCP/IPv6 (#ZZTCP is not in the Configuration Database) on page 1-3
for your installation step. If ZZTCP has been added as a generic process,
perform IIB. Install NonStop TCP/IPv6 (#ZZTCP is in the Configuration
Database) on page 1-4 for your installation step.)
4. Save the system configuration database by entering the SCF command. Substitute
the numbering scheme for your system for the variable (01.04). For information
about numbering versions of your system configuration database, see the SCF
Reference Manual for G-Series RVUs or the SCF Reference Manual for H-
Series RVUs.
IIA. Install NonStop TCP/IPv6 (#ZZTCP is not in
the Configuration Database)
If you do not already have #ZZTCP in the system configuration database, follow this
procedure for installing NonStop TCP/IPv6.
1. Check considerations that affect your configuration by reviewing the TCP/IPv6
Migration Guide.
2. Add the TCP6MAN process to the system configuration database by entering
these SCF commands:
(For more information about SCF commands for the configuration database, see
the SCF Reference Manual for the Kernel Subsystem.)
3. Check that $ZZTCP has been added to the system configuration database by
entering this SCF command:
->STATUS PROCESS $ZZKRN.#ZZTCP
->SAVE CONFIGURATI0N 01.04
Note. See Configuration Database Management on page 6-14 and Falling Back to
Conventional TCP/IP or Parallel Library TCP/IP on page 6-26.
->ADD PROCESS $ZZKRN.#ZZTCP,BACKUPCPU 1, DEFAULTVOL &
$SYSTEM.SYSTEM, HOMETERM $ZHOME, NAME $ZZTCP, &
OUTFILE $ZHOME, PRIMARYCPU 0, PRIORITY 180, &
PROGRAM $SYSTEM.SYSTEM.TCP6MAN, STARTMODE SYSTEM, &
STARTUPMSG "<BCKP-CPU>", STOPMODE SYSMSG
->INFO PROCESS $ZZKRN.#ZZTCP, DETAIL