TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Reference for NonStop TCP/IPv6
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
8-192
STATUS SUBNET Command for TCP6SAM
Prefix State
indicates the current state of the IPv6 prefix address. Possible values are:
Valid Lifetime
indicates the maximum valid lifetime of the prefix.
Preferred Timer
indicates the time interval in seconds that the prefix remains in the preferred state.
Preferred Lifetime
indicates the preferred lifetime of the prefix.
Valid Timer
indicates the time interval in seconds that the prefix remains valid.
Considerations

Following the START SUBNET command, a configured tunnel SUBNET is left in
the STARTING state if the IPTSRC IPv4 address is not configured in the system.
The state changes from STARTING to STARTED when the IPTSRC IPv4 address
is configured in the system.

Following the START SUBNET command, an automatic tunnel SUBNET is left in
the STARTING state if there is no IPv4 address configured in the system. The
SUBNET is automatically configured and placed in the STARTED state as soon as
there is an IPv4 address configured in the system.
STATUS SUBNET Command for TCP6SAM
This command displays the status of the SUBNETs configured in the TCP6MON
process on the TCP6SAM primary processor. This is a nonsensitive command.
NONE No state assigned
PREFERRED IPv6 prefix in preferred state
DEPRECATED IPv6 prefix in deprecated state
STATIC Added by an operator