TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
C-7
Effect. The command is rejected with the reason.
Recovery. Abort the associated SUBNET/brother and reissue the command.
TCPIPV6 00039
Cause. The failover brother was already associated with another SUBNET.
Effect. The command is rejected with the reason.
Recovery. Reissue the command using another SUBNET not linked in a failover pair.
TCPIPV6 00040
Cause. The command is invalid in the failover-enabled SUBNET. Causes include:

For a failover-enabled SUBNET, the ADDALIAS is not allowed until the SUBNET is
associated with another SUBNET as a failover pair.

For a failover-enabled SUBNET, the DELETEALIAS is not allowed.

For a failover-enabled SUBNET, the ALTER SUBNET, IPADDDRESS or ALTER
SUBNET, SUBNETMASK command is not allowed.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with correct parameters.
TCPIPV6 00041
Cause. This command is not valid for IPv6 configuration. Either a required parameter
is missing or mismatched parameters were detected in the command.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with correct parameters.
TCPIPV6 E00039 The FAILOVER brother was already associated
with other subnet.
TCPIPV6 E00040 The command is not valid for FAILOVER enabled
subnet.
TCPIPV6 E00041 The command is not valid for configuring
AF_INET6 subnet.