TCP/IPv6 Configuration and Management Manual (G06.29+, H06.03+, J06.03+)

SCF Error Messages
HP NonStop TCP/IPv6 Configuration and Management Manual—524523-012
C-11

Multiple entries created with the ALLENTRY ON attribute specified in the
command results in one of the generated entry names exceeding the eight-
character limit.
Effect. The command is rejected with the reason.
Recovery. Reissue the command with a correct entry name.
TCPIPV6 00053
Cause. MAC address is changed.
Effect. The command is rejected with the reason. The SUBNET will be in STARTING
state.
Recovery. Stop the subnet and restart the SUBNET.
TCPIPV6 00054
Cause. The ADD SUBNET command was rejected because many different logical-
network partitions exist in the system.
Effect. The ADD SUBNET command is not performed.
Recovery. Reissue the command using an existing partition.
TCPIPV6 00055
Cause. The LNPTPLIST contains a SAM process, which is already part of an existing
LNP entry.
Effect. The ADD SUBNET command fails.
Recovery. Use an existing partition, and resubmit the command.
TCPIPV6 00056
Cause. The ADD SUBNET command was rejected because the LNP list has more
than two names.
TCPIPV6 E00053 The MAC address has been changed with the
current subnet configuration.
TCPIPV6 E00054 Too many logical network partions, maximum 64.
TCPIPV6 E00055 TCP6SAM name mismatch with existing LNP.
TCPIPV6 E00056 Too many TCP6SAM names in LNP list, maximum of
2 allowed.