Telserv Manual

Telserv Error Messages Sent to Terminals
Telserv Manual—427174-009
A-2
TELNET Error Messages
Recovery. Make sure that you have specified the host name or address correctly. If
the TELNET port is not 23, specify the correct port number.
Cause. TELNET cannot set the mode you specified because of the error specified by
error-number.
Effect. The mode is not set.
Recovery. See Recovering From Errors at the beginning of this appendix.
Cause. An error occurred when TELNET tried to switch modes from line-to-character
or character-to-line.
Effect. The mode is not switched.
Recovery. See Recovering From Errors” at the beginning of this appendix.
Cause. An error occurred when TELNET tried to turn echo on or off.
Effect. Echoing remains in the same state as it was before you issued the command.
Recovery. See Recovering From Errors at the beginning of this appendix.
Cause. An error occurred when TELNET tried to turn carriage return mode on or off.
Effect. The spacing is not changed.
Recovery. See Recovering From Errors
at the beginning of this appendix.
Cause. The remote host closed your TELNET connection. This message appears
when you close the connection.
Effect. Your session with the remote host is terminated.
Can't set mode number on term err error-number
Can't turn off/on crmod err error-number
Can't turn off/on echo err error-number
Can't turn off/on spacing err error-number
Connection closed by foreign host