Telserv Manual

Telserv Error Messages Sent to Terminals
Telserv Manual—427174-009
A-4
TELNET Error Messages
Effect. TELNET terminates.
Ask your system administrator if the TCP/IP process is running. See “
Cause. TELNET could not bind to the specified subnet IP address because of the
following error: error-code.
Effect. The run command is not executed.
Recovery. Retry the command. Make sure that you are using the correct subnet IP
address.
Cause. TELNET was unable to connect to the host for the reason specified by
error-reason.
Effect. The connection that you requested is not established.
Recovery. See Recovering From Errors at the beginning of this appendix.
Cause. TELNET detected an internal error while resolving the host name and service
that the user entered.
Effect. TELNET terminates.
Recovery. Contact your system administrator.
Cause. TELNET detected an internal error while parsing the send command that you
entered.
Effect. The command is not executed.
Recovery. Try entering the command again. Make sure that you are using the correct
syntax.
TELNET: bind-nw failed with error no.: error-code
TELNET: connect error-reason
TELNET: getaddrinfo: error-message
TELNET 'send' error - argument disappeared!
TELNET: tcp/telnet unknown service