Telserv Manual

Telserv Error Messages Sent to Terminals

Telserv Manual—427174-009

A-7

Telserv Error Messages

Cause. No windows are available. The number of virtual terminals, or windows, has

exceeded the limit set for the process by the SCF MAXTERMINALS attribute, and only

dynamic services are configured.

Effect. Service selection is not performed and the connection terminates.

Recovery. As a terminal user, you can take no direct action. Ask the system

administrator or operator to either increase the MAXTERMINALS limit for the process

or free some windows.

Cause. Either the Login object is not licensed, or Login could not launch the

application. Failure to launch could be caused by several problems. For example,

Telserv might be busy, or the application object might be corrupted.

Effect. You cannot launch the application.

Recovery. As a terminal user, you can take no direct action. Ask the system

administrator to:



License the Login object if it is not licensed (see the LICENSE command in the File

Utility Program (FUP) Reference Manual), or



Replace the application object, or



Check to see whether related CPUs are down.

Cause. There has been no activity at this terminal for too long.

Effect. The user is disconnected after repeated warning messages.

Recovery. Maintain activity on the terminal, or ask the system administrator to use

SCF to disable the banner time-out value or time-out value for the process.

Sorry, too many users

Sorry, Login session aborted... Try later

***WARNING*** Terminal will be disconnected if it stays idle