Telserv Manual

Telserv Manual—427174-009
B-1
B
SCF Error Messages for Telserv
This appendix provides you with information for interpreting Telserv subsystem error
messages generated by the Telserv process. Italicized words in the message
descriptions stand for values that are inserted by the Telserv process.
Error messages are identified by a 5-digit number preceded by the character E. You
can use the SCF HELP command to display the text of a message; for example, when
the system displays:
TELSERV E00001
You can enter the following command to display the text of the message:
-> HELP TELSERV 1
For detailed information on error messages, see the appendix on error numbers and
error lists in the TCP/IP TELNET Management Programming Manual.
1
Cause. A command was issued with an illegal attribute value.
Effect. The command does not execute.
Recovery. Issue the command again with values within the valid range.
2
Cause. The STOP command was issued against an object with active opens.
Effect. The command does not execute.
Recovery. Either stop all processes that have the specified window open and issue
the STOP command again, or issue the ABORT command. The ABORT command
stops windows without regard to any process that has the window open. This response
might cause the processes with open windows to fail.
TELSERV E00001 Invalid attribute value: name for object-name
TELSERV E00002 object-name cannot be stopped because it has
active opens.