Telserv Manual

SCF Error Messages for Telserv
Telserv Manual—427174-009
B-2
3
Cause. SERVICETYPE in this ADD command is different from the SERVICETYPE
associated with the SERVICENAME already defined.
Effect. The command does not execute.
Recovery. Change the SERVICETYPE or SERVICENAME in this ADD command to
be consistent with each other.
4
Cause. Specified attribute values are within range, but are not valid in the presence of
other attributes. For example, CPU is not a valid attribute unless PROGRAM is
specified.
Effect. The command does not execute.
Recovery. Make sure that the CPU, PRI, PARAM, SWAP and LIB attributes are used
with PROGRAM, and the ACCESS attribute is used with OWNER.
5
Cause. Subordinate objects are in the started state.
Effect. The command does not execute.
Recovery. Stop or abort subordinate objects.
6
Cause. The SERVICENAME specified in the ADD WINDOW command is a dynamic
service. A dynamic service automatically creates a window when a session is
established.
Effect. The command does not execute.
Recovery. Make sure that the SERVICENAME specified in the ADD WINDOW
command is a static service.
TELSERV E00003 Inconsistency between SERVICETYPE and
SERVICENAME.
TELSERV E00004 Inconsistency between attribute values: name1
and name2
TELSERV E00005 Subordinate objects active
TELSERV E00006 Cannot add window to a dynamic service.