Telserv Manual

SCF Error Messages for Telserv
Telserv Manual—427174-009
B-4
11
Cause. The specified file or device name does not exist.
Effect. The command does not execute.
Recovery. Reenter the command and specify the correct file or device name.
12
Cause. The file code of the specified file indicates that it is not an executable program.
Executable program files have file code 100. The wrong file was probably specified.
Effect. The command does not execute.
Recovery. Reenter the command and specify the correct file name.
13
Cause. Only one configured window is allowed for a resilient service. An attempt to
add more that one window to a resilient service, or attempt to alter service to resilient
for a service which has more than one window configured has been rejected.
Effect. The command does not execute.
Recovery. For the ADD WINDOW, add a new resilient service and add the window
under the new service. For the ALTER SERVICE command, delete the configured
windows until only one window is left, and then retry the ALTER SERVICE command.
14
Cause. The read count in the WRITREAD request is less than the recommended
response buffer length.
Effect. The command does not execute.
Recovery. Specify a read count greater than or equal to ZCOM-VAL-BUFLEN. Make
sure the buffer you are using is large enough.
TELSERV E00011 File or device name specified for attribute
attribute does not exist.
TELSERV E00012 File specified for attribute attribute is not
an executable program.
TELSERV E00013 Limit exceeded on number of configured windows
for resilient service.
TELSERV E00014 Response buffer too small.