Telserv Manual

SCF Error Messages for Telserv
Telserv Manual—427174-009
B-5
15
Cause. The specified caller IP address is already associated with an existing window
in a different service.
Effect. The command does not execute.
Recovery. Specify a different caller IP address.
16
Cause. Caller IP address must be specified for windows subordinate to a service
whose ASSIGNED attribute has been turned on.
Effect. The command does not execute.
Recovery. Specify caller IP address for the window.
17
Cause. An invalid command was entered in the IPX/SPX environment.
Effect. The command does not execute.
Recovery. Use TCP/IP as the TELSERV transport protocol.
18
Cause. The current maximum number of services is 256.
Effect. The command does not execute.
Recovery. To add a new service delete an existing service or wait till the service count
is below 256.
TELSERV E00015 Specified caller IP address already exits
in another service.
TELSERV E00016 Caller IP address is required for window.
TELSERV E00017 This assigned attribute is not supported
in the IPX/SPX environment.
TELSERV E00018 The maximum number of services has been
exceeded.