Telserv Manual

Starting the Telserv Process
Telserv Manual—427174-009
3-2
Telserv Parameter Names and Values for the TACL
PARAM Command
Table 3-1 lists all parameter names and values supported for the HP Telserv process.
Table 3-1. Telserv Parameter Names and Values in the TACL PARAM
Command (page1of9)
Name Description
ZTNT^TACL^PROGRAM Specifies the file name of a TACL program other
than the default. When TACL is chosen, this alter-
nate TACL program is used.
ZTNT^TRANSPORT^PRO-
CESS^NAME
Specifies the name of the TCP/IP or IPX/SPX pro-
cess to be used as the underlying transport proto-
col.
The syntax is
PARAM ZTNT^TRANSPORT^PROCESS^NAME [\sys-
name].$procname
Use of this feature depends on the availability of
the Socket library (T9550) on the local system.
Telserv will not operate unless T9550 is present on
the local system.
ZTNT^LOG^CONNECTS^
COLLECTOR
Diverts connection and disconnection EMS event
messages to the alternate EMS collector that you
specify. Use this PARAM in conjunction with
ZTNT^LOG^ CONNECTS
The syntax is:
PARAM ZTNT^LOG^CONNECTS^COLLECTOR alt-EMS-
coll
Note that EMS messages other than connection
and disconnection messages continue to be sent
to the standard EMS collector ($0).
ZTNT^HOST^IP Binds Telserv to an IP address.
The syntax is:
PARAM ZTNT^HOST^IP IP-address
The IP address assigned must be a valid numerical
network address, that is, an IPv4 address in
dotted-decimal format or an IPv6 address in
hexadecimal format.
This feature is supported on J06.09 and H06.20
and later J and H-series RVUs.