Telserv Manual

Starting the Telserv Process
Telserv Manual—427174-009
3-4
Telserv Parameter Names and Values for the TACL
PARAM Command
ZTNT^ATP^COMPATIBLE Enables or disables certain features similar to
those in the ATP6100 product. Values are YES or
NO. The default value is NO.
The syntax is:
PARAM ZTNT^ATP^COMPATIBLE (YES | NO)
Setting this PARAM to YES enables the following
features:

In Block mode, the WRITE data portion of a
WRITEREAD procedure call has an EOT
appended to it. (An EOT is normally appended
only to the data portions of a WRITE or READ
call or to the READ data portion of a
WRITEREAD call.)

A CONTROL-12 operation from any opener of
a window results in the termination of the ses-
sion, unless another opener has break-only
access. (Normally, a session is not terminated
upon receipt of a CONTROl-12 request unless
the opener is the last remaining one.)
If this PARAM is set to NO or allowed to default,
these features are not enabled.
Setting this PARAM to YES is not recommended
under normal circumstances because:

The EOT appended in the WRITREAD call
results in Telserv not strictly conforming to the
6530 protocol.

The termination of a session because of a
CONTROL-12 request can cause security
problems.
Table 3-1. Telserv Parameter Names and Values in the TACL PARAM
Command (page3of9)
Name Description