Telserv Manual

Starting the Telserv Process
Telserv Manual—427174-009
3-7
Telserv Parameter Names and Values for the TACL
PARAM Command
ZTNT^LOG^CONNECTS Enables or disables the generation of EMS mes-
sages when a client connects to or disconnects
from Telserv. Values are YES or NO. The default
value is NO.
The syntax is:
PARAM ZTNT^LOG^CONNECTS (YES | NO)
Setting the PARAM value to YES causes Telserv to
generate an EMS connect event message when a
client requests a connection and a corresponding
disconnect message when the client disconnects.
Telserv sends the event messages to the standard
EMS collector ($0).
Each event message contains the following

Window name

Client IP address

Service name

Local-port identifier

The timestamp for the connection and discon-
nection
Because the number of such event messages can
overload the standard EMS collector, you can use
another PARAM along with this one to divert the
messages to an alternate connector. (For a
description of this PARAM, see ZTNT^LOG^ CON-
NECTS^COLLECTOR.)
When the PARAM value is set to NO or is allowed
to default, Telserv does not generate connect or
disconnect event messages. Note that Telserv con-
tinues to generate all other event messages,
regardless of the setting for ZTNT^LOG^CON-
NECTS.
Table 3-1. Telserv Parameter Names and Values in the TACL PARAM
Command (page6of9)
Name Description