Telserv Manual

Starting the Telserv Process
Telserv Manual—427174-009
3-10
Using the RUN Command and Specifying Run
Options
Using the RUN Command and Specifying Run
Options
You create the HP Telserv process by issuing a TACL RUN command.
Following is the RUN command syntax for creating a Telserv process. Note that, if line
breaks are necessary when you enter the command string, it is good practice to insert
ZTNT^SERVICECHOICE^ECHO Enables or disables the echoing of user input
before Telserv accepts the service chosen by the
user. The Values are YES or NO. The default value
is YES.
The syntax is:
PARAM ZTNT^SERVICECHOICE^ECHO (YES | NO)
Setting this PARAM value to YES or allowing it to
default causes Telserv to echo user input.
Setting this PARAM value to NO disables the echo-
ing of the input the user generates while choosing
a service.
Disable echoing when both of the following situa-
tions exist:

Telserv is configured with services that have
the DISPLAY attribute turned off, and

For security reasons, the user selection should
not be displayed on the terminal.
Note that normal echoing will be restored after
Telserv accepts the user’s service choice.
Note. The LOGIN program must reside on the same subvolume as Telserv. Because the
LOGIN program contains privileged code, it must be licensed. The Telserv process must be
started by super.super to support OSS or unauthenticated services other than TACL.
Table 3-1. Telserv Parameter Names and Values in the TACL PARAM
Command (page9of9)
Name Description