Telserv Manual

Telserv Manual—427174-009

5-1

Subsystem Control Facility (SCF)

Commands for Telserv

Table 5-1 lists the SCF commands you can use with the HP Telserv subsystem. The

table shows the object types to which each command applies.

You can enter the following command to obtain detailed syntax information on the

Telserv object types and the commands that apply to them:

HELP TELSERV [ command ] [ object-type ]

The SEL and SUM options, which apply to several of the SCF commands when used

with other communications subsystems, cannot be used with the Telserv subsystem.

The term assumed is used in the examples in this section to refer to the object

specifier that has been specified to the ASSUME command.

The rest of this section describes the syntax of the SCF commands as they apply to

the Telserv subsystem.

If you specify / OUT file-spec / with a command, the output generated by the

command is directed to the specified file.

Commands can be divided into two categories: sensitive and nonsensitive. Sensitive

commands can change the state of the specified object; nonsensitive commands

Table 5-1. SCF Commands for Telserv

Command PROCESS SERVICE WINDOW null

ABORT X X

ADD X X

ALTER X X X

DELETE X X

INFO X X X

LISTOPENS X X

NAMES X X X X

START X

STATS X X X

STATUS X X

STOP X X

TRACE X X

VERSION X X