TFDS Manual

Starting and Configuring TFDS
Tandem Failure Data System (TFDS) Manual—520628-003
3-4
Viewing and Changing TFDS Configuration Options
Using TFDSCOM Commands. For the current equivalent for obsolete command
names, see Appendix B, TFDSCOM Command Migration Table.
To configure TFDS configuration options to be persistent—that is, to still be valid after
a system load—enter the commands through TFDSCOM and execute the SAVE
command. You can temporarily override default settings with TFDSCOM commands,
but unless you execute the SAVE command, the values revert to the default settings
when you restart TFDS.
You can also customize TFDS configuration options by opening and editing the
configuration file. However, the changes made this way do not take effect until you stop
and restart TFDS.
Default Configuration Settings
The following example shows the default TFDS configuration settings:
! TFDS config file updated 01/09/06 06:53
ANALYZEPRIORITY 180
AUTOBACKUP off
AUTODUMP on
AUTORELOAD on 1
AUTOSTIFLE 03 24
BACKUPDELAY 0000
BURSTINTERVAL 336
BURSTNOTIFY 15 10
BURSTSUPPRESSION on
DB-SUBVOL $system.ztfds
DISABLECPUS none
DUMPOVERRIDE off
DUMPVOLUME none
FMDUMP ON
FMDINITPRIORITY 180
FMDPOSTPRIORITY 180
FMDSIZE 1000
IGNORECPUS none
MAXCONDUMPS 01
PROCESSINGDELAY 0001
REMOTENOTIFY off
RETRY-DUMP 01
RETRY-RELOAD 02
TAPE $MARA0
DISALLOWED-VOLUMES none