TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-8
AUTODUMP
AUTODUMP
The AUTODUMP command specifies whether an enabled processor should be
dumped if a CPU DOWN message occurs or an ANALYZE command is issued.
ON
instructs TFDS to dump an enabled processor automatically if a CPU DOWN
message occurs. The default AUTODUMP setting is ON.
OFF
instructs TFDS not to generate a dump, but the incident is still recorded.
Guideline
You can use the abbreviation ad in place of AUTODUMP.
AUTORELOAD
The AUTORELOAD command specifies whether a processor is automatically reloaded
after a CPU DOWN message has been received and, if configured, a dump is
generated.
ON
specifies that the processor is automatically reloaded. The default AUTORELOAD
setting is ON.
time
is the number of seconds that will delay a reload request. The delay range is 1
through 1440. The default value is 1.
OFF
specifies that a processor is not automatically reloaded. If you set this variable to
OFF, you must reload the failed processor manually.
Guidelines
•
You can use the abbreviation ar in place of AUTORELOAD.
•
The TIMEOUT option controls only the delay of the first reload attempt. If it fails,
successive attempts are made every minute until the number of retries (as
specified by RETRY-RELOAD) is exhausted.
AUTODUMP { ON | OFF }
AUTORELOAD { ON [ time ] | OFF }