TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-21
EXIT
ALL
specifies all processors.
Examples
•
This example restores processing of processors 0, 1, and 2 halts:
ENABLECPUS 0 1 2
•
This example restores processing on all processors:
ENABLECPUS ALL
EXIT
The EXIT command exits the TFDSCOM conversational interface.
Guidelines
•
You can use the abbreviation quit in place of EXIT.
•
To reuse the current configuration, use the SAVE command before exiting
TFDSCOM.
•
If you enter Ctrl-Y at the TFDSCOM prompt, TFDSCOM terminates after
displaying:
TFDSCOM> EOF!
FC
The FC command (fix command) lets you repeat or modify the previous command and
reissue it.
The last command line appears. If you do not need to make changes, press Enter to
reissue the command.
Caution. If the first physical processor number configured is not processor 0, you must add a
DISABLECPUS
option for each processor number lower than the number of the first physical
processor (down to 0) configured to avoid receiving an incorrect list of enabled processors with
the TFDSCOM CONFIG command. An incorrect list of enabled processors does not have an
adverse affect on the normal operation of TFDS software.
EXIT
FC