TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-22
FMDINITCPU
To edit the command, enter one of these FC subcommands:
The subcommand begins its operation at the character positioned directly above it. To
stop editing the line, press Enter.
Specify more than one subcommand on a line by separating each subcommand with a
double slash (//).
Example
The following example uses the FC command and the d and i subcommands to get
help on the AUTOBACKUP command:
TFDSCOM> fc
TFDSCOM> HELP AUTODUMP
tfdscom...........ddddiBACKUP
TFDSCOM> HELP AUTOBACKUP
tfdscom......
FMDINITCPU
The FMDINITCPU command specifies the processor to be used for a dump of a halted
processor.
halted-processor-num
is the processor which, if halted, will be dumped by the processor specified in
alternate-processor-num.
alternate-processor-num
is the processor used to dump the halted processor specified in halted-
processor-num.
The default value is the buddy processor. (Processor 0 would be dumped by processor
1 and vice versa.)
Guidelines
•
You can use the abbreviation fic in place if FMDINITCPU.
•
Change the default values only if you have knowledge of the operational
environment and normal application distribution in your system environment.
R | r replacement-string
Replaces one or more characters on a one-for-one
basis.
I | i insertion-string
Inserts one or more characters.
D | d delete character
Deletes one character. Repeat to erase more
characters.
FMDINITCPU halted-processor-num alternate-processor-num