TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-23
FMDINITPRIORITY
FMDINITPRIORITY
The FMDINITPRIORITY command sets the priority to the program that will take the
initial processor dump of the halted processor.
priority
is the process priority. The maximum value is 190. The minimum value is 150. The
default value is 180.
Guidelines
•
You can use the abbreviation fip in place of FMDINITPRIORITY.
•
Change the default value only if you have knowledge of the operational
environment and normal application distribution in your system environment. In a
particular environment, raising the value potentially locks out other tasks from
starting. Lowering the parameter increases the time for the complete processor
memory to be returned to system operation.
Example
This example sets the FMD initial RCVDUMP priority to 150:
FMDINITPRIORITY 150
FMDPOSTPRIORITY
The FMDPOSTPRIORITY command sets the priority of the second processor dump of
the halted processor.
priority
is the process priority assigned to the program that takes the second (partial)
processor dump of the halted processor. The maximum value is 190. The minimum
value is 150. The default value is 180.
Guidelines
•
You can use the abbreviation fpp in place of FMDPOSTPRIORITY.
•
Change the default value only if you have knowledge of the operational
environment and normal application distribution in your system environment. In a
particular environment, raising the value potentially locks out other tasks from
FMDINITPRIORITY priority
FMDPOSTPRIORITY priority