TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-26
HISTORY
HELP events
displays information for all TFDS events.
Examples
•
This example shows the use of HELP to request a list of TFDSCOM commands:
HELP
The list of TFDSCOM commands follows:
•
The following command requests help on the ACQUIREFILES command:
HELP ACQUIREFILES
The syntax for the ACQUIREFILES command follows.
HISTORY
The HISTORY command displays the processing history of TFDS since it started. This
history includes configuration error messages, TFDSCOM commands that changed the
TFDS configuration, normal TFDS processing steps, and any anomalies encountered
during the TFDS process sequences.
Guideline
You can use the abbreviation h in place of HISTORY.
ACQUIREFILES ANALYZE ANALYZEPRIORITY (ap) AUTOBACKUP (ab)
AUTODUMP (ad) AUTORELOAD (ar) AUTOSTIFLE BACKUP
BACKUPDELAY BURSTINTERVAL (bi) BURSTNOTIFY(bn)
BURSTSUPPRESSION (bs) CANCELBACKUP CLOSE CONFIG (c)
CPUS DB-SUBVOL DETAIL (d) DISABLECPUS
DUMPOVERRIDE DUMPVOLUME ENABLECPUS EXIT(quit) FC
FMDINITCPU (fic) FMDINITPRIORITY (fip) FMDPOSTPRIORITY (fpp)
FMDSIZE (fs) FMDUMP (fd) HELP HISTORY (h)
IGNORECPUS IGNOREOPERATORHALTS (ih) INCIDENT MAXCONDUMPS
MAX-DB-ENTRIES PROCESSINGDELAY PURGE
REMOTENOTIFY (rn)REPORT (r) RETRY-DUMP RETRY-RELOAD
SAVE STATUS (s) TAPE TASKS TFDS
ACQUIREFILES filename [ ACTIVE | OFF ]
HISTORY
Note. History data is kept in a circular buffer. Over time, the initial information is overwritten by
later information.