TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-27
IGNORECPUS
Example
Sample HISTORY output:
The incident number is in parentheses. This number enhances the readability of
HISTORY output with multiple simultaneous processing events.
IGNORECPUS
The IGNORECPUS command specifies that a processor be unavailable for processing
CPU DOWN messages.
OFF
clears the status of IGNORECPUS for any processor from a previous
IGNORECPUS command, making it available for processing CPU DOWN
messages.
n
specifies the processors that are ignored by TFDS. Processor numbers range from
0 through 15.
ALL
specifies all processors.
Guidelines
•
You can use the abbreviation ic in place of IGNORECPUS.
•
No processors are ignored in the default setting.
•
This is a single-use command. TFDS clears the OFF status for the specified
processor after it is brought back up. For longer term disabling of specific
processors, see DISABLECPUS on page 4-18.
•
Because it is a one-time only command, IGNORECPUS is useful for actions such
as manually resetting a processor.
•
There is one ignore flag for each processor in the system.
06/13 09:23 Instrumented subsystem triggered TFDS instument
06/13 09:23 (17) No Saveabend Requested
06/13 09:23 (17) --Closing Incident--
06/13 09:23 (17) --Processing Completed for incident--
********End of data********
IGNORECPUS [ OFF ] { 1 [ 2 3 ...n ] | [ ALL ] }