TFDS Manual

Using TFDSCOM Commands
Tandem Failure Data System (TFDS) Manual—520628-003
4-36
STATUS
STATUS
The STATUS command returns a TFDS view of the processors. It shows the processor
status and reload states.
Guideline
•
You can use the abbreviation s in place of STATUS
•
The STATUS display is in this format:
s
is the number of seconds the reload is delayed after the RCVDUMP finishes.
t
is the number of consecutive halts a processor is allowed without surviving for h
hours before reloading is stifled.
h
is the number of hours that a processor must survive in order for its successive
reloads counter to be reset. If the number of successive reloads passes t, reloads
are stifled for h hours.
c
is the processor number.
tfdsst
is the state of TFDS. It can be:
STATUS
TFDS current environment: @01/06/11 08:41:31
Failures are recorded since TFDS started at dateNtime
CPU TFDS CPU CPU Time of last Time of last
No State State Dn R1 Failure Load
-- ------- ---------- -- -- ------------- -------------
c tfdsst cpust fs ft dateNtime dateNtime
c tfdsst cpust fs ft dateNtime dateNtime
AUTORELOAD [ ON [, Delay s seconds ] | OFF ]
AUTOSTIFLE [ Disabled | t Times in h Hours ]
Analyzing Dumped Dumping
Not configured Not dumped Not reloaded
Reloading Takeover Up