TFDS Manual

EMS Messages and Templates
Tandem Failure Data System (TFDS) Manual—520628-003
D-13
EMS Messages
bit 4 = TFDS_PROCESS_STOP
bit 3 = TFDS_PROCESS_CONTINUE
bit 2 = TFDS_CAPTURE_ALL
bit 1 = TFDS_CAPTURE_STACK_TRACE - unused - always get stack trace
bit 0 = TFDS_CAPTURE_SELECTIVE
Cause. For G-series RVUs, TFDS and the TFDS run-time library issue this event to
notify you about an internal software error within the NonStop system. TFDS could
generate this event as a result of a halted processor or any NonStop Kernel subsystem
instrumented with the TFDS run-time library. The event detail should specify the actual
program that caused the event to be generated.
Effect. Depends on the specific problem and severity. This event is dialed out to your
service provider if the system is so configured.
Recovery. Determine the cause of the failure and take appropriate action.
7000
Cause. For G-series RVUs, TFDS issue this event to document the analysis of an
internal software error within the NonStop system. TFDS could generate this event
through use of the TFDSCOM ANALYZE command or by any NSK subsystem
instrumented with the TFDS run-time library, triggering a TFDS instrument with a
severity of INFORMATIVE.
Effect. Depends on the specific problem and severity.
Recovery. Informational message only; no corrective action is needed.
Data Capture Informative *7000* : Incident Symptom String,
Severity n,
Product n, Product Name, File Name, Error Location