TGAL Manual

TAG Command
TGAL Commands
2–68 060865 Tandem Computers Incorporated
TAG Command Use the TAG command to define the revision level of a set of lines. This command
only operates in conjunction with the VERSION command.
When the “version” in the VERSION command and the “footing” in the TAG
command match exactly, TGAL puts a vertical bar next to the lines defined with the
TAG command. Vertical bars appear in the margin on the same side of the page as the
page number. TGAL also prints the footing specified in the TAG command at the
bottom of the page. The command alone indicates that only one line is to be tagged.
The syntax of the TAG command is:
TAG " footing "








ON
OFF
number
B
trigger
footing
specifies the foot to be printed at the bottom of the page.
ON
specifies that all lines between this command and the next TAG OFF command are
to be flagged with a vertical bar.
OFF
indicates the end of the lines that are to be flagged with a vertical bar.
number
is the number of lines to be tagged.
B
specifies that all lines until the next blank line or until the next trigger character,
either alone or as part of another TGAL command, are to be tagged.
trigger
specifies that all lines until the next trigger character, either alone or as part of
another TGAL command, are to be flagged with a vertical bar.