TMF Management Programming Manual (G06.24+)

Commands and Responses
HP NonStop TMF Management Programming Manual—522420-002
5-112
INFO DUMPS
For audit dumps, the volume name $ZTMFAT is a pseudo or dummy name
used to support TMF’s ability to spread audit-files across multiple disk
volumes.
ZSERIAL
specifies the serial number of the dump for which information is to be returned.
If you omit this field, the default is all serial numbers.
ZDUMPTYPE
specifies the type of dump for which information is to be returned. The
following values are valid:
If you omit this field, information about all audit dumps and online dumps is
returned.
ZMASTERSEQUENCE
ZDATASEQUENCE
are not valid for command buffers.
ZDUMPSTATUS
specifies the status of the dumps to be returned. The following values are
valid:
If you omit this field, the default is all of these dump status values.
ZMEDIASTATUS
This field is not valid for command buffers.
ZSORTSELECT
specifies the order in which the dump entries are returned. The following
values are valid:
If you omit this field, the default is ZTMF-VAL-BYNAME.
ZTMF-VAL-AUDITDUMP The dump is an audit dump
ZTMF-VAL-ONLINEDUMP The dump is an online dump
ZTMF-VAL-ASSIGNED The tape volume contains valid dumps
ZTMF-VAL-RELEASED The contents of the tape volume is not required
for file recovery
ZTMF-VAL-INVALID The tape volume cannot be used for file recovery
ZTMF-VAL-BYSERIAL The selected dumps are returned in descending
numeric order by serial number
ZTMF-VAL-BYNAME The selected dumps are returned alphabetically
by file name