TMF Management Programming Manual (G06.24+)

Commands and Responses
HP NonStop TMF Management Programming Manual—522420-002
5-137
RELOCATE DISKDUMPS
ZTMF-ERR-INVALIDDUMPSERIAL
The command failed because the value specified for DUMPSERIAL was
neither the wild value nor a value higher than 63.
ZTMF-ERR-ONLYONEOLDDMLOC
The command failed because there was more than one occurrence of the
ZTMF-TKN-OLDDMLOC token in the input buffer.
ZTMF-ERR-ONLYONENEWDMLOC
The command failed because there was more than one occurrence of the
ZTMF-TKN-NEWDMLOC token in the input buffer.
ZTMF-ERR-WARNNODUMPSRELOCATED
No dumps were relocated because, for example, a specified dump serial
number or OLDDMLOC does not exist.
ZTMF-TKN-DUMPSERIAL
indicates the invalid dump serial number that caused the RELOCATE
DISKDUMPS command to fail.
ZTMF-TKN-OLDDMLOC
indicates the invalid old disk media location that caused the RELOCATE
DISKDUMPS command to fail.
ZTMF-TKN-NEWDMLOC
indicates the invalid new disk media location that caused the RELOCATE
DISKDUMPS command to fail.
Usage Guidelines
Only super-group users can issue this command. TMF must be started before you
issue the RELOCATE DISKDUMPS command.
If a wild card (*) is specified for ZTMF-TKN-OLDDMLOC, a wild card must also be
used for ZTMF-TKN-NEWDMLOC.
For more information about the RELOCATE DISKDUMPS command, see the TMF
Reference Manual.