TMF Management Programming Manual (G06.24+)

Event Messages
HP NonStop TMF Management Programming Manual—522420-002
6-10
TMP Event Messages
286 CONFVOLFILEFSERROR File-system error occurred while accessing
the configuration file
287 CONFIGVOLFSERROR File-system error occurred while accessing
the configuration file
288 TRANSAUTOABORTED Transaction aborted because AUTOBORT
time limit was exceeded
289 ABORTDUETOAUDOVFLOW Transaction aborted because audit trail to
full
290 OPENMIGRATEFILEERR File-system error during migration to D30
291 READMIGRATEFILEERR File-system error during migration to D30
292 INCMPLTEMIGTOTMF3ERR Migration to D30 failed
296 TRANSPORT Network transaction aborted because it
exceeded the configured disconnect timer
interval.
297 DOWNNODE Network transaction aborted because
there was no reply from the remote node.
298 ALTERDISCONNECT Operator attempted to set the autoabort
timer value lower than the configured
disconnect timer interval.
299 ALTERDISCONNECTTIMER Operator used SNOOP to set a new
disconnect timer value.
322 RM-CREATED Resource added to directory
323 RM-REMOVED Resource removed from directory
324 RM-OPENED Resource manager opened
325 RM-CLOSED Resource manager closed
326 RM-CRASHED Resource manager crashed
329 GiveSwitchRefused PUP PRIMARY or TMFCOM ALTER TMF,
SWITCHPROCESS TMP command was
attempted while TMF was writing to the
audit trails, and audit writing has been
disabled because an audit trail is full
330 AlterSessionIdleTimer Session idle timer was set to a new value
by way of the SNOOP SetSessionIdleTmr
command.
332 AuditRead-Error TMP encountered a problem while
attempting to read an audit-trail file during
a START TMF operation
333 NetGramTimeout NetGram send timer to a remote node was
exceeded
Table 6-1. TMP Event Messages (page 6 of 7)
Event # Symbolic Name (ZTMF-EVT-) Description