TMF Operations and Recovery Guide (G06.24+)

Routine Maintenance
HP NonStop TMF Operations and Recovery Guide—522417-002
2-26
Viewing EMS Messages
If you want to cancel a particular operation, you can use the CANCEL OPERATIONS
command. This command affects only TMF file-recovery and file-dump operations. To
remove other types of operations, you must use the STOP TMF, ABRUPT command.
For example, the following CANCEL OPERATIONS command cancels the operation
identified by operation-number 45:
TMF 54> CANCEL OPERATIONS 45
You can issue the CANCEL OPERATIONS command only if you are a member of the
super user group.
See the TMF Reference Manual for complete instructions on using the STATUS
OPERATIONS, DISPLAY OPERATIONS, and CANCEL OPERATIONS commands,
including instructions for viewing operations for which the operation number has been
reassigned to a more recent operation.
Viewing EMS Messages
TMF sends event messages to the Event Management Service (EMS). The EMS
collects event messages from reporting processes and subsystems and then
selectively distributes those messages to various destinations. Such destinations
range from a local operator console to a management application running on a remote
system. Read these messages as part of your routine TMF maintenance to get a view
of the system as reported by each TMF operation. There are several ways to view
EMS messages. This section describes using ViewPoint and using the TMFCOM
DISPLAY OPERATIONS command.
You can view EMS messages using the ViewPoint application event screen.
See the ViewPoint Manual for instructions on using this application.
The ViewPoint Primary Events screen displays messages as follows:
2002-03-10 15:59 PRIMARY EVENTS Page 20
END
Coll: \SF.$0 Filter: FLTRDFLT Action: 0 Critical: 65
16:02 \SF TMF *0008* TMP $TMP : Rollover to audit file $MAT.ZTMFAT.AA...
16:02 \SF TMF *0061* TMP $TMP : Release of audit trail file $MAT.ZTMFAT...
16:02 \SF TACL TERMINAL I/O EROR 201, \SF.06,143
16:05 \SF TMF *0208* AuditDump $DUMP : Audit trail $MAT.ZTMFAT.AA002654
16:07 \SF $SPLS DEV $TD3.#D33 NOT READY
16:07 \SF TMF *0208* AuditDump $DUMP : Audit trail $MAT.ZTMFAT.AA002654
16:07 \SF TMF *0054* TMP $TMP : Audit dump $DUMP successfully dumped audit
16:07 \SF TMF *0063* TMP $TMP : Release of audit trail file $MAT.ZTMFAT...
16:12 \SF TMF *0006* TMP $TMP : Renamed audit file $MAT.ZTMFAT.AA002654
F1=TACL F2=Status F3=P-Event SF3=A-Event F4=Last Event F6=Ack
F8=Freeze SF8=Thaw F9=Print F10=Clip F11=Detail F12=Config
F14=Profile SF14=Recover F15=Help SF15=Extra SF16=Detail