TMF Operations and Recovery Guide (G06.26+)

Overview of TMF Maintenance and Recovery
HP NonStop TMF Operations and Recovery Guide—522417-003
1-8
Displaying Configuration Attributes
overflowthreshold The percentage of the active-audit volumes’ capacity that
can be used before TMF begins copying the oldest audit-
trail files to the overflow volumes.
begintransdisable The percentage of the active-audit volumes’ capacity that
can be used before new transactions cannot start. When
the used capacity falls below this percentage, new
transactions are allowed.
MaxRetainedATFiles Maximum number of audit-trail files to be retained on
restore-audit volumes indefinitely after recovery processes
no longer need them.
OverflowVols The overflow-audit volume names, as specified in an ADD
or ALTER AUDITTRAIL command.
RestoreVols The restore-audit volume names, as specified in an ADD or
ALTER AUDITTRAIL command.
Audit Dump Configuration
{ Master | Auxiliary01…15 } The audit trail with which this audit dump process is
associated.
Status Status of audit dump process, either enabled or disabled.
medium { tape | disk } Whether audit dumps are copied to tape or disk.
DiskMedia For disk dumps, the fully qualified name of the volume to
which the dump is directed.
Catalog Configuration
retaindepth The number of online dump and associated audit dump
generations that are to remain in the TMF catalog, as
specified in an ALTER CATALOG command.
released { off | on } Tells whether a dump tape’s status changes to Released
(On) or Scratch (Off) when the tape is marked for deletion.
roundrobin ROUNDROBIN attribute setting. If ON, the catalog is
searched in round-robin fashion, so that all tapes in the
catalog are used before any are re-used. If OFF, the
catalog is searched in the standard way, so that the first
available tape after the beginning of the tape list is used.
Table 1-4. Understanding the INFO TMF Display (page2of3)
Heading/Attribute Meaning