TMF Operations and Recovery Guide (G06.26+)

Routine Maintenance

HP NonStop TMF Operations and Recovery Guide—522417-003

2-28

Viewing EMS Messages

TMF sends event messages to the Event Management Service (EMS). The EMS

collects event messages from reporting processes and subsystems and then

selectively distributes those messages to various destinations. Such destinations

range from a local operator console to a management application running on a remote

system. Read these messages as part of your routine TMF maintenance to get a view

of the system as reported by each TMF operation. There are several ways to view

EMS messages. This section describes using ViewPoint and using the TMFCOM

DISPLAY OPERATIONS command.

You can view EMS messages using the ViewPoint application event screen.

See the ViewPoint Manual for instructions on using this application.

The ViewPoint Primary Events screen displays messages as follows:

To see details about any message, you can press the F11 key to see the Event Detail

Screen.

2002-03-10 15:59 PRIMARY EVENTS Page 20

END

Coll: \SF.$0 Filter: FLTRDFLT Action: 0 Critical: 65

16:02 \SF TMF *0008* TMP $TMP : Rollover to audit file $MAT.ZTMFAT.AA...

16:02 \SF TMF *0061* TMP $TMP : Release of audit trail file $MAT.ZTMFAT...

16:02 \SF TACL TERMINAL I/O EROR 201, \SF.06,143

16:05 \SF TMF *0208* AuditDump $DUMP : Audit trail $MAT.ZTMFAT.AA002654

16:07 \SF $SPLS DEV $TD3.#D33 NOT READY

16:07 \SF TMF *0208* AuditDump $DUMP : Audit trail $MAT.ZTMFAT.AA002654

16:07 \SF TMF *0054* TMP $TMP : Audit dump $DUMP successfully dumped audit

16:07 \SF TMF *0063* TMP $TMP : Release of audit trail file $MAT.ZTMFAT...

16:12 \SF TMF *0006* TMP $TMP : Renamed audit file $MAT.ZTMFAT.AA002654

F1=TACL F2=Status F3=P-Event SF3=A-Event F4=Last Event F6=Ack

F8=Freeze SF8=Thaw F9=Print F10=Clip F11=Detail F12=Config

F14=Profile SF14=Recover F15=Help SF15=Extra SF16=Detail

2002-03-10 16:03 EVENT DETAIL Page 1 END

2002-03-10 16:02:22 \SF.$TMP HP.TMF.D10 008 TMF *0008* TMP $TMP :

Rollover to audit file $MAT.ZTMFAT.AA002655.

Cause:

The Transaction Monitor Process (TMP) rolled over an audit file.

Effect:

The operation completes.

Recovery:

Informative message only; no corrective action is needed.

F9=Print F10=Clip F11=Next SF14=Recover F15=Help F16=Return