TMF Planning and Configuration Guide (G06.24+)

About This Guide

HP NonStop TMF Planning and Configuration Guide—522416-004

viii

How This Guide Is Organized

Section 1, Concepts and Capabilities, describes basic planning and configuration

activities for TMF. It also describes how to delete an entire TMF configuration and why

you might want to do so.

Section 2, Doing an Initial Configuration, provides advice for doing your initial TMF

configuration.

Section 3, Reconfiguring Audit Trails, describes how to reconfigure audit trails and

when you might want to do so.

Section 4, Reconfiguring Transaction Limits, describes how to reconfigure limits for

transactions and when you might want to do so.

Section 5, Configuring TMF for Backup and Recovery, describes TMF backup and

recovery, including configuration of audit dumps.

Section 6, Reconfiguring TMF Processes, describes how to reconfigure TMF

processes and when you might want to do so.

Appendix A, Moving Between Earlier TMF Environments and D46, describes how to

change your application environment from an earlier TMF product to the D46 product,

and back again, if necessary.

Appendix B, Configuration Worksheets, provides worksheets for you to use in planning

and recording your TMF configuration. It shows the default values (for parameters that

have defaults) and provides space to enter the values you currently have specified. It

also shows the TMFCOM commands and command parameters you use to specify

each value.

TMF Documentation

Readers of this manual may also refer to the following documentation describing TMF:

Audience Title

All readers TMF Introduction

TMF Glossary

System managers

and operators

TMF Planning and Configuration Guide (This manual)

TMF Operations and Recovery Guide

TMF Reference Manual

Application pro-

grammers

TMF Application Programmer’s Guide

TMF Management Programming Manual