TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-174
INFO PROCESS
For most attributes, when the standard default value is in effect, the INFO PROCESS
command displays the default value followed by the notation “- Default Value.” In a few
cases, however, the command does not retrieve the actual default value and instead
displays only the notation “(Default)” next to the attribute name. For more information
about default values, see the ALTER PROCESS command description, earlier in this
section.
In the INFO PROCESS display, attribute values that cannot be altered for a process
type are indicated by the notation “- Not Alterable.”
Examples
The following INFO PROCESS command displays the attributes common to all
backout processes. (In the display, the SYSnn subvolume shown for the ProgramFile
attribute indicates the operating system cold-load SYSnn, used by default.)
TMF 11> INFO PROCESS BACKOUT
Process Configuration:
BackOut:
Pri 149 - Default Value
CPUS ( Default )
MakeSaveAbend On - Default Value
Debug Off - Default Value
Inspect On - Default Value
ExtendedSegSize ( 5 , 30 ) - Default Value
PFSSize 1048576 - Not Alterable
ProgramFile $SYSTEM.SYSnn.TMFBOUT - Default Value
TERM $YMIOP.#CLCI - Default Value
Swap ( Default ) - KMSF Is Used
ProgramFile Name of program file used by process type.
Term Name of terminal used by process type.
Swap Name of swap file specified for process type, followed by the notation
“KSMF is Used.” For more information about SWAP file assignment
and this notation, see the ALTER PROCESS
command discussion.
Table 3-12. INFO PROCESS Output
Heading or Item Description