TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-184
INFO TMF
require TMF to be running will not be executed unless you modify the file by adding
a START TMF command preceding these commands.
Output Displayed
The primary items presented by the INFO TMF display are listed in the command
descriptions for the following commands:
•
INFO AUDITTRAIL (Table 3-7)
•
INFO AUDITDUMP (Table 3-6)
•
INFO CATALOG (Table 3-9)
•
INFO BEGINTRANS (if TMF is started) (Table 3-8)
Examples
The following INFO TMF command presents the combined attribute display:
TMF 40> INFO TMF
Configuration Volume:
$SYSTEM
AuditTrail Configuration:
Master
ActiveVols: $AUDIT
Subvolume ZTMFAT, Prefix AA, filesize 600, filespervolume 3,
auditdump On, overflowthreshold 80%, begintransdisable 90%
MaxRetainedATFiles 0
OverflowVols: $MEZRPT, $OPER
Restorevols: $MEZRPT
Auditdump Configuration:
Master: enabled, medium tape, Copies 1, verifytape Off,
blocksize 28, system \CYCLONE
Catalog Configuration:
retaindepth 3, released off, roundrobin off
BeginTrans Configuration:
TransCountThresh (1500,1600)
TmfLibMemThresh (90,95)
TmpMemThresh (90,95)
TransPerCpu (1024,1024)
Autoabort 7200 Seconds
RecRMCount 256
RMOpenPerCpu 96
BranchesPerRM 128
After the next START TMF, the BeginTrans Configuration will be:
TransPerCpu (1024, 1024)
RecRMCount 256
RMOpenPerCpu 96
Note. To augment the information captured through the INFO TMF, CNFG command, you can
capture current information about TMF online and audit dumps by using the INFO DUMPS,
OBEYFORM command. For more information about this step, see INFO DUMPS on
page 3-165.