TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-206
RECOVER FILES
UNLOAD {ON | OFF}
determines whether the tape volume is unloaded after it has been used. ON
unloads the tape volume. OFF suppresses unloading. The default is ON.
TOPHYSVOL volume
identifies the physical target volume on which TMF should place the recovered
files. If you specify both the TOPHYSVOL and the WHEREPHYSVOLIS options,
the WHEREPHYSVOLIS option takes precedence.
WHEREPHYSVOLIS volume
identifies the original physical volumes where the files specified in the file-set
parameter are stored. This option limits the files to be recovered to those that
reside on the physical volumes. If you specify both the TOPHYSVOL and the
WHEREPHYSVOLIS options, the WHEREPHYSVOLIS option takes precedence.
RECOVERVDPPHASE1
recovers the underlying catalog for the virtual disk process (VDP). If you omit this
option, the files specified in file-set are recovered, but the catalog is not.
MAP NAME[S] {old-fileset-list TO new-fileset}
{(old-fileset-list TO new-fileset
[,old-fileset-list TO new-fleset]...)}
allows files to be recovered to different volumes, subvolumes, and file IDs than the
ones from which they were dumped. The new (target) files, however, must be
located on the same node (system) and same instance of TMF as the old (source)
files.
When you select the MAP NAMES option, TMF always also uses the
FROMARCHIVE option, even if you do not explicitly select it.
Caution. The TOPHYSVOL option is intended for use with NonStop Storage Management
Foundation (SMF) files only. Before you issue a RECOVER FILES command with this option, it
is vital that you read Options for the SMF Product on page 3-212.
Caution. The WHEREPHYSVOLIS option is intended for use with SMF files only. Before you
issue a RECOVER FILES command with this option, it is vital that you read Options for the
SMF Product on page 3-212.
Caution. The RECOVERVDPPHASE1 option is intended for use with SMF files only. Before
you issue a RECOVER FILES command with this option, it is vital that you read Options for
the SMF Product on page 3-212.
Note. If you specify the MAP NAMES option, you cannot use the RECOVERVDPPHASE1
option.