TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-252
SHOW DUMPS
SHOW DUMPS
The SHOW DUMPS command displays the attribute values established by SET
DUMPS commands in the current TMFCOM session.
DISKMEDIA
for a dump to disk, displays the DISKMEDIA setting, indicating the node, volume,
subvolume, and disk on which the dump is located.
TAPEMEDIA
for a dump to tape, displays the TAPEMEDIA setting, indicating the tape volume on
which the dump is stored.
SERIAL
displays the SERIAL setting, indicating the serial number of the dump added to
the catalog.
TYPE
displays the TYPE setting, specifying the type of dump (audit or online) added to
the catalog.
*
displays all dump specification values established by the SET DUMPS command
in this session. If you do not specify any option, this is the default.
Security Restrictions
Anyone can enter the SHOW DUMPS command.
TMF State Requirement
You can enter the SHOW DUMPS command at any time, whether or not TMF has
been started.
SHOW DUMPS [attribute [, attribute]...]
[ * ]
where attribute is:
[DISKMEDIA]
[TAPEMEDIA]
[SERIAL ]
[TYPE ]