TMF Reference Manual (G06.24+)

TMFCOM Commands
HP NonStop TMF Reference Manual—522418-002
3-255
SHOW TAPEMEDIA
*
displays all tape media specification values established by the SET TAPEMEDIA
command in this session. If you do not specify any option, this is the default.
Security Restrictions
Anyone can enter the SHOW TAPEMEDIA command.
TMF State Requirement
You can enter the SHOW TAPEMEDIA command at any time, whether or not TMF has
been started.
Usage Guidelines
The SHOW TAPEMEDIA command does not display default values for attributes.
If no parameter is specified, SHOW TAPEMEDIA displays the values of all
specifications set by SET TAPEMEDIA commands during this session.
If a SET TAPEMEDIA command was not issued during the session, the SHOW
TAPEMEDIA command presents no information.
Output Displayed
The SHOW TAPEMEDIA command displays the values of the specifications listed
under the syntax description earlier in this discussion. For details about these
specifications, see the ADD TAPEMEDIA or SET TAPEMEDIA command description.
Examples
The following SHOW TAPEMEDIA command displays the specification values for tape
volumes set by a previous SET TAPEMEDIA command:
TMF 36> SET TAPEMEDIA LABEL ON!, UNLOAD ON
.
.
.
TMF 50> SHOW TAPEMEDIA
label on !
unload on
If the SET TAPEMEDIA command has not been used in this session, the SHOW
TAPEMEDIA command presents no display:
TMF 10> SHOW TAPEMEDIA
TMF 11>