TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-10
Message Descriptions
11
transaction-id
is the invalid transaction identifier.
Cause. The command specified one or more wild-card characters (*) in its
transaction-id parameter list. However, only fully qualified transaction identifiers
can be used in this command.
Effect. The command fails.
Recovery. Enter a STATUS TRANSACTIONS * command to list the valid transactions
in the system. Then, re-enter the previous command, using only fully qualified
transaction identifiers.
12
Cause. The command specified an invalid transaction state in the STATE parameter.
Effect. The command fails.
Recovery. Re-enter the command, specifying one of the following entries in the
STATE parameter: ACTIVE, ABORTED, ABORTING, COMMITTED, ENDING, HUNG,
or PREPARED. For more information about these states, see the STATUS
TRANSACTIONS command description in Section 3, TMFCOM Commands.
13
Cause. A Subsystem Programmatic Interface (SPI) violation occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
In this context, a TransID cannot contain wild-card
characters. The invalid TransID is transaction-id.
The command specified an invalid STATE parameter. STATE must
specify ACTIVE, ABORTED, ABORTING, COMMITTED, ENDING, HUNG,
or PREPARED.
An output-only field in the structure for this command was
not NULL on input.