TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-16
Message Descriptions
42
Cause. The command specified an invalid BLOCKSIZE parameter used to set the
data-block density at which dumps are written to tape. The value specified in
BLOCKSIZE, multiplied by 1024, gives the block size in bytes. For BLOCKSIZE, you
can specify one of the following values: 4, 8, 12, 16, 20, 24, 28, 32, 36, 40, 44, 48, 52.
The maximum block size is also limited by the density at which the tape drive writes
data.
Effect. The command fails.
Recovery. Re-enter the command, using a valid BLOCKSIZE: an integral multiple of
4, in the range of 4 through 52.
43
Cause. A Subsystem Programmatic Interface (SPI) violation occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
44
Cause. The command included a volume name that contained wild-card characters;
however, a complete volume name must be used in this command.
Effect. The command fails.
Recovery. Re-enter the command, using a complete volume name.
The command specified an invalid BLOCKSIZE parameter.
A structure must be supplied with this command.
In this context, the command cannot specify a VOLUME name
that contains wild-card characters.