TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-21
Message Descriptions
60
Cause. The command specified an improper INVALID parameter used to determine
whether a file is available for use in file recovery. You must set INVALID to either ON
(to indicate that the file is available) or OFF (to indicate that it is not available).
Effect. The command fails.
Recovery. Re-enter the command with the INVALID parameter set to either ON or
OFF.
61
Cause. A Subsystem Programmatic Interface (SPI) error occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
64
Cause. The command specified an invalid SYSTEM parameter used to indicate the
node to which dumps are written or from which files are recovered.
Effect. The command fails.
Recovery. Verify that the node name consists of a backslash (\) followed by one to
seven alphanumeric characters, and that the first alphanumeric character is a letter.
Then, re-enter the command, specifying the valid node name in the SYSTEM
parameter.
The command specified an improper INVALID parameter.
The command specified an invalid MaxResp value. The
specified value must be greater than or equal to -1. Contact
the Global Customer Support Center (GCSC) or your service
provider.
The command specified an invalid SYSTEM (node) name.