TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-42
Message Descriptions
133
Cause. A TMF error occurred.
Effect. The command fails.
Recovery. This message should never appear. Make a note of the command entered
and the circumstances. Then, contact the GCSC or your service provider.
134
Cause. The command specified a value for the FILESPERVOLUME parameter that
did not fall within the proper limit, an integer from 1 through 100. This parameter
determines the number of files in the audit trail that reside on each active-audit volume
configured.
Effect. The command fails.
Recovery. Re-enter the command, setting FILESPERVOLUME to an integer from 1 to
100, or omitting this parameter altogether so that the default value of 5 applies.
135
Cause. The command specified a value for the FILESIZE parameter that did not fall
within the proper limit, an integer from 1 through 2047. This parameter specifies the
size of the audit-trail file, in megabytes.
Effect. The command fails.
Recovery. Re-enter the command, setting FILESIZE to an integer from 1 to 2047, or
omitting this parameter altogether so that the default value of 100 applies.
Subsystem Error: The value of the AuditDump attribute must be
ON or OFF.
The value specified for FILESPERVOLUME is invalid.
The value specified for FILESIZE is invalid.