TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-44
Message Descriptions
139
Cause. A TMF error occurred.
Effect. The command fails.
Recovery. This command should never appear. Make a note of the command
entered and the circumstances. Then, contact the GCSC or your service provider.
140
Cause. A STATUS OPERATIONS command that included the TYPE parameter also
referred to a specific TMF operation. When TYPE is included, however, the command
must specify the wild-card (*) character rather than a particular operation number.
TYPE then acts as a filter to display all operations of the type indicated.
Effect. The command fails.
Recovery. Re-enter the command, substituting the wild-card character in place of the
operation number.
141
Cause. A STATUS OPERATIONS command that included the STATE parameter also
referred to a specific TMF operation. When STATE is included, however, the
command must specify the wild-card (*) character rather than a particular operation
number. STATE then acts as a filter to display all operations in the state indicated.
Effect. The command fails.
Recovery. Re-enter the command, substituting the wild-card character in place of the
operation number.
Subsystem Error: This command can specify only one
AuditTrailId.
A STATUS OPERATIONS command that specified the TYPE parameter
also specified an operation number.
A STATUS OPERATIONS command that specified the STATE
parameter also specified an operation number.