TMF Reference Manual (G06.24+)

TMFCOM Messages
HP NonStop TMF Reference Manual—522418-002
A-100
Message Descriptions
334
volume
is the name of the volume specified in the command.
at-volume-type
is the volume type specified in the command.
Cause. The command attempted to remove an audit volume of type at-volume-
type, but the volume is not configured as that type. For example, perhaps the
command attempted to delete an ACTIVEVOL named $VOL1, but $VOL1 is configured
as an OVERFLOWVOL.
Effect. The command fails.
Recovery. Re-enter the command, making sure that the volume you name is the
appropriate type.
335
Cause. An ALTER AUDITTRAIL command was issued with the ADDACTIVEVOL
option, but TMF startup has not yet progressed sufficiently to allow processing of the
request.
Effect. The command fails.
Recovery. Wait until the data volume portion of TMF has been started before
attempting to add active volumes to the audit trail configuration. Use the STATUS
DATAVOLS command to determine if data volume service is started.
Volume volume cannot be deleted as at-volume-type because it
is not configured as that type.
This command cannot add an active volume when data volume
service is not started.